Author Message
Admin
Admin



Joined : 12 Apr 2008
Posts : 19
Location : Pocono Lake, PA

Subject: How do you use a dowsing rod? Sat Apr 12, 2008 5:29 pm
How do you use a dowsing rod?

Submitted by Jack on 08/Apr/2008


Admin
Admin



Joined : 12 Apr 2008
Posts : 19
Location : Pocono Lake, PA

Subject: How do you use a dowsing rod? Sat Apr 12, 2008 5:30 pm
Start with the L-rod. It is the most commonly used field instrument. Hold the rod by the short end pointing the long end in front of you. Do not put your thumb over the bend as this will impede the swing. Now comes the fun part.

You are actually giving your subconscious orders but you pretend you are talking to the rods.

Hold the rods about shoulder width apart. Keep loose. Hold the rods parallel to the floor.. This will help hold the rods steady.

Now say "rods I want you to cross for a yes or affirmative answer. "Give me a yes". You make them do it by physically crossing the rods. (I am not a strict as some teachers. If the rods want to open for a yes, so be it. Just be sure that you always get the same response for a yes answer.) I have found that sometimes it helps to set up a target and tell the rods to cross when your feet is over the target. The important thing is to get a response.

To get a no answer ask your rods to move in the opposite way than for a yes. In other words, if you have programmed your rods to cross for a yes, now program to open for a no.

To be proficient, you need to be able to get a consistent yes-no answer....
~Donna


Submitted by Donna..CHIPS Paranormal on 08/Apr/2008


Admin
Admin



Joined : 12 Apr 2008
Posts : 19
Location : Pocono Lake, PA

Subject: How do you use a dowsing rod? Sat Apr 12, 2008 5:31 pm
Dowsing Rod:

A forked twig said to move when held over ground in which water, metal etc. is to be found. Usually done with a "Y" shaped twig, the individual dowsing will hold the stick by the forked end, and use the single end as a pointer. "Following" the rod will lead the dowser to the water/metal he is seeking, and vibrates when nearing the target in question.

Submitted by Jeff - CHIPS on 08/Apr/2008